Hi again guys ,
Thanks for heads up on the cable guides , I have purchased some and they are a lot neater and better .
well I finally gave the bike a ride out which was great but had to cut it short due to a fork issue, its making a clunking noise on the rebound .
I’ve just removed the damper as I’m thinking that this could be the problem and having done some searching I’m thinking about getting new seals but I could do with help first .
So here s the damper
And would this be the right seal kit -
Here’s a better picture of the o-rings from a seller on eBay, same kit number KF236
To me this kit doesn’t look like the right one ? so would anyone know ?
Also the shaft has a screw down inside it here -
I was reading somewhere that the upper o-rings / seals could not be replaced due needing a press for the Rebuild .
I did try to undo this screw but it’s very tight .
This is my first time with a Headshok damper so any info would be greatly appreciated .
I haven’t got onto the fluid part yet but will do once I figure this part out .
Many thanks guys .
Scott